DRIVE DOWN BAILER (BALL BOTTOM)

 

 

Drive Down Bailers are made of a barrel to hold the sand and a ball or flapper type check valve on the bottom. Usually, the very bottom of these bailers are cut off at an angle to make a horseshoe shape. They are used successfully in bailing mud and shale and are loaded merely by running them down in the mud and pulling back out.  

 

SPECIFICATIONS

  1 1/4" 1 1/2" 1 5/8" 1 3/4"
Fishneck O.D. 1.188" 1.188" 1.375" 1.375"
Max. O.D. 1.250" 1.500" 1.625" 1.750"
Pin Connection 15/16"-10 15/16"-10 15/16"-10 15/16"-10
Made Up Length       60.938" 60.875" 60.938" 60.938"
Ball 3/4" 1" 1" 1 1/8"
Steel Pin 3/16" x 1 1/4"    3/16" x 1 1/2"    3/16" x 1 5/8"     3/16" x 1 3/4"

 

ASSEMBLY (COARSE THREAD)

  1 1/4" 1 1/2" 1 5/8" 1 3/4"
Part Number            50DD0125     50DD0150     50DD0163     50DD0175

 

COMPONENTS (COARSE THREAD)

  1 1/4" 1 1/2" 1 5/8" 1 3/4"
Fishneck 50DD2125 50DD2150 50DD2158 50DD2175
Load Barrel       50B01345 50B01346 50B01342 50B01348
Ball Bottom 50SB7125     50SB7150     50SB7158     50SB7175

 

ASSEMBLY (FINE THREAD)

  1 1/4" 1 1/2" 1 5/8" 1 3/4"
Part Number            50DD3125     50DD3150     50DD3163     50DD3175

 

COMPONENTS (FINE THREAD)

  1 1/4" 1 1/2" 1 5/8" 1 3/4"
Fishneck 50DDF125 50DDF150 50DDF158 50DDF175
Load Barrel       50B01420 50B01427 50B01434 50B01441
Ball Bottom 50FT7125       50FT7150       50FT7163       50FT7175